Vacuum Concentrator CentriVap

As many as 148 samples may be processed at once

Microprocessor-controlled centrifugal motion up to 1725 RPM eliminates bumping and foaming common when applying vacuum during evaporation and maximizes recovery of trace solutes

Once run time has expired or the RUN/STOP button is pressed, within seconds the vacuum pump stops, the valve opens to bleed air into the chamber, and the rotor stops

Automatic vacuum release valve prevents loss of sample by releasing the vacuum before the rotor stops and during power failures

Lid latch with safety sensor locks the lid in place when the rotor is turning and prevents start up when the lid is open

Built-in vacuum delay prevents bumping by allowing the rotor to achieve speed before applying vacuum

Corrosion-resistant sample chamber accommodates accessory rotors for a wide variety of sample tubes

Large phenol-free lid seal ensures good vacuum without potential for phenol contamination

Microprocessor-controlled 300-watt heater speeds evaporation by supplying a controlled amount of heat from OFF up to a maximum of 100° C in one degree increments

Three Quick-Start™ Buttons store one user-set program each

Easy-to-read LCD display prompts the user to set program parameters and displays program number, actual and set point temperatures, heat time remaining, run time remaining, and if Heat Boost™ is activated

Heat and run times are set separately, each from 1 to 999 minutes, so that heat may be programmed to shut down sooner than the run to protect heat sensitive samples from excessive heat exposure after the solvent has evaporated

Audible alarm signals completion of set point run time